Product ID:PHILLYBOND 6 HARDENER
MSDS Date:03/25/1994
FSC:8040
NIIN:01-061-4995
Kit Part:Y
MSDS Number: CFQXG

ITW PHILADELPHIA RESINS

130 COMMERCE DR
MONTGOMERYVILLE, PA 18936
US

Emergency Phone: 800-424-9300 (CHEMTREC)

Info Phone: 215-855-8450

Cage: ITWPH

ITW PHILADELPHIA RESINS

454 MONTGOMERYVILLE, PA 18936 US

Telephone: 508-777-1100

Cage: ITWPH

FORMALDEHYDE POLYMER WITH PHENOL AND TETA

CAS: 32610-77-6

Fraction By Weight: 30-40%

OSHA PEL N/K

ACGIH TLV: N/K

TRIETHYLENETETRAMINE; (TETA)

CAS: 112-24-3

RTECS: YE6650000

Fraction By Weight: <5%

OSHA PEL N/K

ACGIH TLV: N/K

(ORAL, RAT) 414 MG/KG

CAS: 108-95-2

RTECS: SJ3325000

Fraction By Weight: <7%

OSHA PEL 5 PPM, S

ACGIH TLV: 5 PPM, S

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

0 LBS/GAL (EPA REFERENCE METHOD

RTECS: 9999999VO

OSHA PEL N/K

ACGIH TLV: N/K

LD50 LC50 Mixture:SEE INGREDIENT 3
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES: MODERATE EYE IRRITANT. SKIN:
MODERATE SKIN IRRITANT. INHALATION: PROLONGED INHALATION OF HEATED
VAPORS MAY CAUSE IRRITATION OF THE NOSE, THROAT AND RESPIRATORY
TRACT. INGESTION: LIQUID MAY CAUSE SEVERE DAMAGE TO MUCOUS
MEMBRANES IF SWALLOWED. CHRONIC: REPEATED EXCESSIVE OVEREXPOSURES
TO PHENOL (EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ: HAVE CAUSED LIVER AND KIDNEY EFFECTS
IN LAB ANIMALS. REPEATED EXCESSIVE OVEREXPOSURES TO THIS PRODUCT
MAY CAUSE SKIN SENSITIZATION.
Medical Cond Aggravated by Exposure:ASTHMA. CHRONIC RESPIRATORY DISEASE
(EG BRONCHITIS, EMPHYSEMA). EYE DISEASE. SKIN DISORDERS AND
ALLERGIES.

First Aid:EYES: FLUSH EYES WITH PLENTY OF WATER FOR AT LEAST 15 MINUTES
WHILE HOLDING EYELIDS OPEN. GET PROMPT MEDICAL ATTENTION. SKIN:
WASH AFFECTED AREA WITH PLENTY OF SOAP AND WATER FOR AT LEAST 15
MINUTES. IF SYMPTOMS PERSIST, CONTACT MD. INHAL:REMOVE TO FRESH
AIR AND PROVIDE OXYGEN IF BREATHING IS DIFFICULT. GET MEDICAL
ATTENTION OF EFFECTS OCCUR. INGEST: DO NOT INDUCE VOMITING. GIVE
WATER OR (SUPDAT)

Flash Point Method:PMCC
Flash Point:200F,93C
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, FOAM.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA AND FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:CLOSED CONTAINERS MAY RUPTURE WHEN
EXPOSED TO HIGH HEAT.

Spill Release Procedures:AVOID PERSONAL CONTACT. ABSORB ON INERT
MATERIAL SUCH AS SAND, EARTH OR VERMICULITE AND PLACE INTO A
SUITABLE LABELED CONTAINER FOR WASTE DISPOSAL. RESIDUE MAY BE
CLEANED WITH A SAFETY SOLVENT. WEAR A DEQUATE PROTECTIVE CLOTHING.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:STORE IN A COOL, DRY PLACE W/ADEQ
VENT. KEEP AWAY FROM OPEN FLAME & HIGH TEMPS. PRACTICE GOOD
HOUSEKEEPING PROCS TO AVOID ALL SKIN CONTACT & (SUPDAT)
Other Precautions:TAKE PROPER PRECS AGAINS OVEREXP TO DUSTS THAT MAY BE
GENERATED FROM SANDING OR MACHINING CURED MATL; THESE WILL INCL
TALC, FOR WHICH A TLV-TWA OF 2 MG/M3 HAS BEEN ESTABLISHED &
NUISANCE DUSTS FOR WHI CH TLV OF 10 MG/M3 SHOULD BE OBSERVED.

Respiratory Protection:NIOSH APPROVED RESPIRATORY PROTECTION REQUIRED
IN THE ABSENCE OF PROPER ENVIRONMENTAL CONTROL. FOR EMERGENCIES, A
NIOSH APPROVED SELF-CONTAINED BREATHING APPARATUS OR FULL-FACE
RESPIRATOR IS RECOMMEND ED.
Ventilation:MATL IS IN PASTE FORM. VAPS WILL NOT READILY FORM. WHEN
WORKING IN CONFINED AREAS, NIOSH APPRVD RESPIRATORS ARE REQD.
Protective Gloves:CHEMICAL RESISTANT RUBBER GLOVES.
Eye Protection:ANSI APPRVD CHEM WORKERS GOGGLES .
Other Protective Equipment:ANSI APPROVED EYE WASH & DELUGE SHOWER .
LONG SLEEVE CLOTHING.
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
FIRST AID PROC: MILK IF AVAILABLE. SEEK MEDICAL ATTENTION IMMEDIATELY.
HNDLG/STOR PRECS: BRTHG OF VAPS. WASH THOROUGHLY AFTER HNDLG &
BEFORE SMOKING, EATING OR USING TOILET FACILITIES. AVOID PRLNGD/RP
TD INHAL OF HEATED VAPS OR SPRAY MISTS.AVOID PRLNGD/RPTD SKIN
CONTACT. KEEP AWAY FROM HEAT.

Spec Gravity:1.72
Evaporation Rate & Reference:NON-VOLATILE (BUAC=1)
Solubility in Water:APPRECIABLE
Appearance and Odor:BLACK PASTE WITH AMINE ODOR.

Stability Indicator/Materials to Avoid:YES
MINERAL ACID, OXIDIZING MATERIALS AND EPOXY RESINS UNDER CONTROLLED
CONDITIONS.
Stability Condition to Avoid:AVOID MIXING WITH LARGE QUANTITIES OF
RESIN AS HEAT IS EVOLVED.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE AND
OXIDES OF NITROGEN.

Waste Disposal Methods:DISPOSE OF IN ACCORDANCE WITH FEDERAL, STATE AND
LOCAL REGULATIONS. APPLICABLE CERCLA/RCRA HAZARDOUS WASTE CODES:
U188 (PHENOL). RQ UNDER CERCLA, 10000 POUNDS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.